Search results for: wa 0812 2782 5310 moulding dinding tangga berpengalaman plupuh sragen in all categories
No results found containing all search terms. 14 results found containing some search terms.
... 5 seconds. Dry the model after dipping for 5 minutes at 100 C. Moulds crack Not adhering to preheat times Adhere to investment during preheating and temperature instructions ...
URL: https://www.dentaurum.de/files/989-845-20.pdf
... Porosity in casting 23 Ring: cracks 16 Retentions: closed 18 Shrinkage 24 Silicone mould: investment material adhesions 9 model casting technology en 3 Problem analysis in working ...
URL: https://www.dentaurum.de/files/989-800-20.pdf
... for alloys, having a more or less pronounced melting range. However, the mould has to be filled completely within a very short time. Dr. Jürgen ...
URL: https://www.dentaurum.de/files/Titanium_Implant_Supra_MA03_spectrum.pdf
... rings must be early removed during the setting process for an unhindered expansion of the mould. 12 Part 2 – Influences on the expansion 2.4 Storage temperature Phosphate-bonded investment ...
URL: https://www.dentaurum.de/files/989-879-20.pdf
... available, mix thoroughly by hand. Allow investment material to flow into the duplicating mould on a vibrator. Avoid 8. bubbles. Depending on the elasticity of ...
URL: https://www.dentaurum.de/files/989-761-60.pdf
... Without any further standing time, the investment material is poured into the dry hollow mould (observe the prescribed mixing ratio) . After about 40 minutes' setting ...
URL: https://www.dentaurum.de/files/989-821-00.pdf
... Figure 11. rema dynamic S (powder Figure 12. Completed filling of the mould. inside the silicone mould with rema dynamic and liquid) . S and ...
URL: https://www.dentaurum.de/files/MillingTechnique7.pdf
... and 16) . After applying Star the area of the bar inside the silicone mould 11 and 12) for the check of the space con- Wax M ...
URL: https://www.dentaurum.de/files/MillingTechnique6.pdf
... producers offered a design program that would immediately show flashes after devesting because the investment mould had been a digital pattern after the job order planning which at best should ...
URL: https://www.dentaurum.de/files/Creating_3D_printed_denture_frameworks_that_fit.pdf
... point of the printed object with the sprue former. Roughen the top of the mould after the material has set. Recommendation: Remove the cylinder from the preheating ...
URL: https://www.dentaurum.de/files/989-802-49.pdf